Williams Sound Switch PFM T31 User Manual

PFM T31 Transmitter  
PRODUCT IS REPLACEMENT OF THE PRODUCT. NO PERSON HAS ANY AUTHORI-  
TY TO BIND WILLIAMS SOUND TO ANY REPRESENTATION OR WARRANTY WITH  
RESPECT TO THE PFM T31 TRANSMITTER. UNAUTHORIZED REPAIRS OR MODIFI-  
CATIONS WILL VOID THE WARRANTY.  
Instructions For Use & Care  
Thank you for purchasing the PFM T31 transmitter from Williams Sound. The T31 trans-  
mitter is designed to operate with a wide-band FM, 72–76 MHz receiver. For optimal per-  
formance, we recommend using the Williams Sound R31 or R32 receiver. Please call a  
Williams Sound representative for more information: 800-843-3544.  
How it Works: The T31 transmitter uses a microphone (not included) to pick up the desired  
sound source. The speaker talks into the microphone, and the T31 transmitter broadcasts the  
message over an FM radio signal. Listeners wear FM receivers to pickup the broadcast and  
hear the speaker’s message.  
The exclusions and limitations set out above are not intended to, and should not be construed  
so as to contravene mandatory provisions of applicable law. If any part or term of this  
Disclaimer of Warranty is held to be illegal, unenforceable or in conflict with applicable law  
by a court of competent jurisdiction, the validity of the remaining portions of this Disclaimer  
of Warranty shall not be affected, and all rights and obligations shall be construed and  
enforced as if this Limited Warranty did not contain the particular part or term held to be  
invalid.  
If you experience difficulty with your system, call Toll-Free for Customer Assistance:  
1-800-843-3544  
Components:  
PFM T31 Body pack transmitter  
On/Off Switch  
BAT 001 AA Alkaline Batteries  
If it is necessary to return the system for service, your Customer Service Representative will  
give you a Return Authorization Number (RA) and shipping instructions.  
Mic  
Off  
FM  
On  
Mic  
Instructions:  
Williams Sound FM  
Pack the system carefully and send it to:  
Before you begin, make sure you have AA  
Alkaline batteries installed in the transmit-  
ter. See Battery Information on page 2.  
Williams Sound Corp.  
Attn: Repair Dept.  
Mic Jack  
Mic Mute Switch  
1. Plug the microphone into the “mic” jack  
on top of the transmitter.  
10321 West 70th Street  
Eden Prairie, MN 55344  
the switch to the “Off” position. This will  
eliminate any unwanted noise as a result of  
the transmitter being on.  
2. Turn the power on: Place the FM switch  
to the “On” position.  
Note: The microphone cord is also the  
transmitting antenna. For maximum range,  
make sure the microphone cord is hanging  
as straight as possible.  
3. Position the microphone as close to the  
speaker’s mouth as practical.  
4. When you are ready to speak, turn the  
Mic Mute Switch to the “On” position.  
When you are done speaking, mute the mic  
by turning  
5. Remember to turn the transmitter off  
when you are done using it: Turn the “FM”  
switch to the “Off” position.  
®
10321 West 70th St., Eden Prairie, MN 55344 U.S.A.  
MAN 109C  
©2005, Williams Sound Corp.  
800.843.3544 | 952.943.2252 | FAX: 952.943.2174  
®
MAN 109C ©2005, Williams Sound Corp.  
 

Weider Home Gym WEBE08900 User Manual
Well Traveled Living Indoor Fireplace 60351 User Manual
Westinghouse Saw SS576 User Manual
Whirlpool Double Oven AKZM 656 User Manual
Whirlpool Ice Maker 2180913 User Manual
Xantrex Technology Power Supply ENET XFR3 User Manual
Xerox Network Card 098S04703 User Manual
Zanussi Washer Dryer FLS 522 C User Manual
Zanussi Washer FJ 1094 G User Manual
Zenoah Brush Cutter BK3402FL User Manual