Yamaha Guitar CGX 111SC User Manual

NOMENCLATURE  
Control Section  
Battery Holder  
Pickup  
Electret Film Type  
ELECTRIC  
ACOUSTIC GUITAR  
Owner’s Manual  
Pickup  
Condenser Mic  
(System 43 only)  
Thank you for choosing a Yamaha electric-acoustic guitar.  
In order to make the most of the advanced features and  
performance provided by your guitar, please read this  
manual carefully before using the instrument.  
Output Jack (with power switch function)  
PRECAUTIONS  
The output jack is an EIAJ-standard 1/4" phone jack. Be sure to use an  
appropriate connection cable.  
THE CONTROLS  
The built-in preamplifier is automatically turned on when a plug is  
inserted into the output jack. When not using the instrument, or when  
playing it without amplification, be sure to remove the plug from the  
output jack so that the preamplifier power is turned off.  
System 42 (1 way)  
System 43 (2 way)  
w
w
r
6
6
8
4
8
4
Always set the VOLUME control to “0” when plugging in or unplugging  
the connection cable.  
10  
12  
HIGH  
2
0
10  
12  
OFF  
2
0
2
2
q
q
HIGH  
4
4
BATT.  
e
Reverse Normal  
e
The battery check indicator (BAT.) will light briefly when a plug is  
inserted or removed from the output jack. This is normal and does not  
indicate a malfunction.  
MIC.  
4
6
BATT.  
6
6
6
8
8
8
4
4
8
4
2
0
10  
12  
10  
12  
VOL.  
10  
12  
2
0
10  
12  
VOL.  
2
0
2
0
LOW  
LOW  
Be sure to remove the battery if the instrument will not be used for an  
extended period of time in order to prevent possible damage due to  
battery leakage.  
q Volume Control  
This knob controls the volume.  
r Mic (Phase Adjustment)  
* System 43 only  
When the mic knob is set to its cen-  
ter position, the mic is off.  
w BATT. (Battery Check) Lamp  
SPECIFICATIONS  
Rotate the knob to the right (Normal)  
to increase the mic mix level. At this  
time, if feedback or howling occurs,  
it is possible to reverse the phase  
by rotating the knob to the left.  
The same knob provides control of  
both level and phase adjustment.  
When battery power is low the lamp will  
light. Please replace the battery with a  
new set as soon as possible. (Refer to  
“BATTERY REPLACEMENT" section.)  
System  
Pickup  
Electret Film Type  
SYSTEM-42 (1 way) SYSTEM-43 (2 way)  
EMF : B-Band22L  
EMF : B-Band22L  
YAMAHA : MC-7  
Omni Directional Condenser Mic  
e Equalizer Controls  
Pre-amplifier Controls  
HIGH, LOW, VOLUME HIGH, LOW, VOLUME  
MIC. (Phase Adjust)  
When both the HIGH and LOW knobs  
are set to "0", the signal will be flat (EQ  
Pass).  
HIGH: Rotate the knob to the right to  
enhance the high frequencies  
and create a brighter sound.  
LOW : Rotate the knob to the right to  
enhance the low frequencies  
and add presence.  
Output jack  
Combination end pin/power switch  
Caution  
Output impedance  
Power supply  
10 k  
Rotating the HIGH and LOW knobs  
to the right increases the overall  
output level. Likewise, rotating the  
MIC. knob right or left also in-  
creases the overall output level. If  
the overall output level is increased  
in this manner, use the VOL. knob  
to adjust the volume level.  
9V DC, S-006P (6F22) dry cell battery  
Battery life (continuous use)  
Power consumption  
Model  
Approx. 340 hours  
Approx. 1.7 mA  
CGX-111SC  
Approx. 150 hours  
Approx. 3.8 mA  
CGX-171CC  
BATTERY REPLACEMENT  
Be sure to replace the battery as soon as possible when the battery check  
indicator lights in order to avoid reduced sound quality.  
CONDENSER MIC ADJUSTMENT (System 43 only)  
* Be sure to remove the battery if the instrument will not be used for an  
extended period of time in order to prevent possible damage due to  
battery leakage.  
The condenser mic is attached inside the body (behind the preamplifier) with a  
flexible pipe that allows free adjustment of the mic's direction.  
A variety of tone variations are achievable by changing the direction of the mic  
head.  
q Press the catch on the battery holder in  
the direction indicated by the arrow in the  
illustration in order to unlock it.  
w Slide out the battery case.  
Battery case  
• When the guitar was shipped from the factory, the mic head is positioned  
inside the body slightly pointed towards the sound hole and about 10mm  
from the guitar's top. (You can see it from the sound hole.) This setting is  
good for picking up the sound of the strings being plucked. (See diagram 1)  
OPEN  
OPEN  
• When the mic head is slightly pointing toward the inside of the body this  
setting will pickup a bigger body sound. (See diagram 2)  
* Try some different mic placements and select the one you prefer.  
Catch  
(Diagram 1)  
Strings  
r Slide the battery case back  
into the battery holder and  
press firmly so that the  
battery case locks into  
place.  
e Remove the old battery from the battery  
case, and insert the new battery making  
sure that the (+) and (–) terminals of the  
battery are positioned as shown in the  
illustration. Use only a DC9V, S-006P  
(6F22) or equivalent battery.  
10 mm  
Mic Head  
DC9V  
OPEN  
(Diagram 2)  
S-006P (6F22)  
Toward the  
center of  
the body  
 

West Bend Bread Maker L5141 User Manual
Westinghouse Flat Panel Television LTV 30w2 User Manual
Whirlpool Air Conditioner ACPE102PS2 User Manual
Whirlpool Air Conditioner ACS082PP0 User Manual
Whirlpool Refrigerator WRS526SIAE User Manual
Whirlpool Washer Dryer 3LER5436EQ0 User Manual
Xerox Copier MO3096Y6 1 User Manual
Yamaha Music Mixer AW2816 User Manual
Yamaha Portable Generator EF1600, EF2600, YG2600 User Manual
Zanussi Washer TL1033 User Manual